吸附物式干機

◆服務優勢 Product features

※含有維持一致性的吸氣心理壓力和露點

1.溶解塔之相對高度與孔徑經實驗性導致精細計算公式，塔床障礙小，維持了壓縮視頻固體空氣干燥劑5秒的碰到時間間隔，符合制成品氣的露點需求。

2.30％的晾干劑數量，代替補償費晾干劑的物種多樣性老化試驗，抓實晾干。

3.小型擴散轉移器，為了確保暖濕氣流平滑借助干燥的劑層，清除溝流想象。

※可再生氣量耗損少于14％

1.匠心的機筒設計方案，存放100％的吸咐形成，保存的形成用做增強降解時間段的降解氣濕度，的提升設施設備的解吸本事，使降解更完全徹底。

2.太干和可回收利用運用方向熱對流方案范文，濕暖空氣穿過干的溶解劑追訴時效果比較好。可回收利用氣出入口含濕量調節在亞過剩階段，使消音器器及泄壓閥工作區無返潮之慮。

3.可按照其低溫干燥機的工作根據意愿調粉碎氣需求量，以保證粉碎空氣持續固定，粉碎壓力值低至臨介。

※干躁劑用到壽命短長

1.適合的的機筒盡寸，使氣體憑借干熱劑層的氣速和時長提高好的形態，有力發揮出干熱劑的耐腐蝕性。

2.有效率的模式配備，在空氣來到機筒前，經除油治療按時快速清理空氣中內植物油成分物與重環境污物，杜絕粗糙劑層受環境的污染。

※機進行了先進高品質電動三輪及氣動彈簧閥和穩定的全光電可編寫程序序掌握器，組排程序界面親善，手動聯續顯視雙塔工程狀況，循環法周期怎么算現場報道可編，設備調整10min。閘閥蓄電量有50萬次健身動作。

※封頭開口處作冷冷鍍防起繡凈化處理，10年不生銹。

※運作明確、功能不穩、運作簡變，按照不要基礎條件。

※Bend it out on the same has the stable pressure and dew point

1. The height and diameter adsorption tower by the experimental results calculated precisely, tower, ensure the small resistance bed compressed gas desiccant 5 seconds contact time, meet the requirements of the finished product angry dew point.

2.30% of the surplus, desiccant used to compensate for the natural aging, ensure desiccant dry.

3. Large diffuser, ensure uniform through the desiccant air layer, eliminate channel flow phenomenon.

※Bend the gas loss less than 14% renewable

1. Excellent barrel design, save 100% of the adsorption quantity of heat, storage quantity of heat is used to increase the regeneration stage again angry temperature, improve equipment desorption ability, make renewable more thoroughly.

2. Dry and regeneration of the reverse convection scheme, wet air through the dry when the adsorbent best effect. Getting angry export moisture content control in the saturated state, the muffler and exhaust passage without concentrations of condensation.

3. According to the operation of the dryer load demand adjust dosage, ensure again angry for stability, regeneration renewable air pressure low to critical.

※Bend desiccant long service life

1. The right of barrel size, make the gas through the desiccant flow velocity and time of layer be the best, give full play to the desiccant performance.

2. The reasonable system configuration, in the air into the barrel, except by the efficient before oil processing timely removal in the air in content and heavy oil pollutant, avoid desiccant layer contamination.

※The equipment adopts bend novel high quality and pneumatic valve electric and advanced and reliable full electronic programmable controller, friendly interface, automatic continuous display of the twin towers, working cycle, the programmable factory set 10 min. The valve life for 500000 times action.

※Bend the cylinder body wall be cold galvanizing antirust processing, 10 years don't rust.

※Bend action, stable performance, accurate, easy operation and installation with no need of foundation.

◆核心科技性能 Main technical parameters